Diagnodent instruction manual

Instructions for use DIAGNOdent pen 1 User instructions | Service 6 / 44 Target group This document is for dentists and dental office staff. Service Please direct all questions regarding the product, service, and maintenance to the fol‐ lowing addresses. Please refer to the serial number of the product in all inquiries! Service-Hotline:File Size: 2MB. a) Press the “MENU” button once followed by the save/ enter button holding tip/unit in the air away from direct sun or halogen light. b) When tone begins, gently place the tip on calibration disc at 90º angle, holding steady. c) Calibration is complete when tone stops. d) Calibration cab be confirmed by holding tip to disc, number on display should match number on disc +/- 3. Early Cavity Detection Laser.

Operating Instructions KaVo DIAGNOdent as of Serial No. Always on the safe side. Vertrieb/distribution: KaVo Dental GmbH Bismarckring 39 • D Biberach Tel.: 0 73 51 / • Fax: 0 73 51 / 1 22 14 Hersteller/manufacturer: Kaltenbach Voigt GmbH Bismarckring Diagnodent. The traditional way to detect cavities has always been with x-rays and by feel with the dental explorer. While these methods are accurate, the newest technology in cavity detection, the diagnodent, is used in our office. The diagnodent is an instrument that detects decay by scanning your tooth with a pain- free laser. Early Cavity Detection Laser.

KaVo DIAGNOdent 2 Austria: KaVo Dentalwarenhandels-gesellsch. mbH Gutheil-Schoder-Gasse 7a A - Wien Telefon: +43 1 66 50 Telefax: +43 1 66 50 Instructions for use DIAGNOdent pen 5 Operation | Turning on/off Turning on/off Start up Hold the start button ① for approximately 1 second until the signal sounds and the display appears. Switch off Note After 90 seconds of non-use, the DIAGNOdent pen automatically turns off. a) Press the “MENU” button once followed by the save/ enter button holding tip/unit in the air away from direct sun or halogen light. b) When tone begins, gently place the tip on calibration disc at 90º angle, holding steady. c) Calibration is complete when tone stops. d) Calibration cab be confirmed by holding tip to disc, number on display should match number on disc +/- 3.