Hks evc-s manual

Quick Manual ELECTRONIC VALVE CONTROLLER types Turn on the EVC-S @To turn on (or off) the EVC-S, press the center of the switch longer @ Press the right side of the switch to set the Response Value. ("RSP" appears on the monitor.) RSP Boost n Increase ('Q Press the upper or lower side of the switch to enter a number. Decrease the Response Va lue.  · Shops Part Reviews. HKS EVC-S Review. Jump to Latest Follow.  · I was having trouble passing smog with the manual boost controller the previous owner installed so I finally got around to installing a hks evc-s to control the boost. I ripped out the manual boost controller and to save time, I tee'd the hks unit into the .

HKS EVC-S Boost Controller Specification. Since the introduction of their first boost controller in , HKS have been at the pinnacle of electronic boost control. Fresh from HKS, the "EVC-S" is from the EVC product series for price-conscious customers. This EVC-S utilises a stand alone solenoid and has simplified features compared to previous. , HKS U.S.A., INC. bar to PSI Conversion Table ELECTRONIC VALVE CONTROLLER IV INSTALLATION INSTRUCTIONS PART # RA NOTICE. Read this entire manual to understand how the EVC IV functions before beginning the installation process. Do not attempt to Install or adjust the EVC IV without thorough knowledge of how this unit works. Hey guys, just installed the HKS EVC-S and with it turned off the car runs 12psi off the wastegate spring (tial 38mm), but when i turn it on, it just boosts insanely ( bar @ half throttle @ rpm) at any setting. I went over the manual twice, i'm sure it is set up correctly. here's the schematic for a poppet valve (which the tial is i.

3) Reproduction of all or any part of this manual without written consent from HKS Co. Ltd. is prohibited unless stated by law. 5. Disclaimer HKS Co. Ltd. will not be held responsible for any damages caused to the vehicle(s) or to the computer(s) by use of this software. HKS Co. Ltd. cannot guarantee that this product will suit the users. EVC-S can control up to kPa (36PSI) Simple Boost Setting Directly input simple values to modes A and B, and let the HKS EVC control the boost. Return Function The boost setting returns to the factory setting when the power is turned off. On some vehicles, the boost value may be lower than the boost before installing the EVC-S. This manual indicates items you need to pay attention to in order to install this product safely and lists precautions to avoid any possible damage and/or accidents. For any missing, defective and/or damaged parts, contact your Authorized HKS Dealer.