How do you use a manual blood pressure cuff

Devices with an upper arm cuff provide the most accurate blood pressure readings. Wrist cuffs should not be used unless the patient cannot use an upper arm cuff due to arm size being too large to fit a cuff or for medical reasons. Finger devices should never be used. Clinical guidelines do not recommend the use of finger devices because they. Hold the stethoscope in place with one hand and the pump with the other. Turn the screw of the pump bulb clockwise several times to close the airflow valve. Squeeze the bulb rapidly while watching the dial on the gauge increase to indicate the pressure. Keep squeezing until the gauge reads between and www.doorway.ruted Reading Time: 4 mins.  · Advertisement. Just use the cuff, then inflate and deflate it properly, the result of your systolic and diastolic pressure will be displayed digitally. For more detailed information on how to use both manual and digital monitors, and how to find the accurate blood pressure readings, visit this previous section!

The HEMC Manual Inflation Blood Pressure Monitor is intended for home use. SAVE THESE INSTRUCTIONS Before Using the Monitor www.doorway.ru2-IM 2/23/10 AM Page 3. To assure the correct use of the product basic safety measures should always be followed including the precautions listed below. About Press Copyright Contact us Creators Advertise Developers Terms Privacy Policy Safety How YouTube works Test new features Press Copyright Contact us Creators. The cuff pressure at this point is the MAP. The cuff then fully deflates opening up the artery, promoting more laminar flow, and reducing oscillations. When we're first taught to perform manual blood pressure with auscultation and Korotkoff sounds, we can discern the systolic and diastolic pressures based on when oscillations begin and end.

Positioning the Blood Pressure Cuff 1. Place your index and middle fingers over the inside center of your inner elbow. When you press lightly you should be 2. Wrap the cuff around your arm. Tuck the cuff end through the metal loop and slide it onto your upper arm. 3. Check the tightness of the. First, make sure the bladder is fully deflated when you check the position of the needle on the gauge. To be % sure, you can unhook the air hose from the bladder. Next, you need to return the needle to zero. You can do this by taking a pair of pliers and turning the nozzle on the dial gauge. You will need to inflate the cuff to about mm Hg (millimeters of mercury) over your normal blood pressure. If you are unsure, then you can always consult your doctor to find out how much to inflate the cuff. After you have inflated the pressure cuff, now place the stethoscope using the flat side down on the crease of your elbow.